Place the drum near a downspout, drill a hole in the side near the bottom and screw in a drain valve. That’s an OK installation if you plan to run a soaker hose to your garden. But if you want to use a wand or a spray nozzle, you’ll need to elevate the barrel on a stand for more water pressure. Water is heavy (55 gallons weighs 440 lbs.), so use 4×4 treated lumber for the legs and secure everything with construction screws or stainless steel lags. But don’t place the stand on soft ground. You could kill somebody if the rig toppled over. If you have large gardens and want to store more water, double-size the stand and add a second barrel.
Cut holes in the bottoms of the barrels with a 2-1/4-in. hole saw. Then screw in a 2-in. male threaded electrical (gray PVC) conduit adapter (electrical adapters aren’t tapered like plumbing adapters, so you can tighten them down all the way). Squirt a thin bead of silicone caulk around the opening and screw on a threaded electrical PVC coupler to cinch the barrel between the two fittings (see Figure A). Next, glue together sections of 2-in. PVC pipe, unions (to make winter disassembly easier), reducers and valves. As long as you’re at it, install an overflow pipe so you can direct the excess where you want it.
Finally, cut a hole in one of the covers and mount a screen to filter out leaves and debris. Then just wait for the next big rain.
Have the necessary tools for this DIY project lined up before you start—you’ll save time and frustration.
- Cordless drill
Hole saw, 2-1/4 in
Avoid last-minute shopping trips by having all your materials ready ahead of time. Here’s a list.
- 55-gal. barrel with lid
- 4×4 treated lumber and construction screws or stainless steel lags, if you build a stand to elevate the rain barrel(s)
- 2-in. male threaded electrical (gray PVC) conduit adapter
- 2-in. female threaded electrical (gray PVC) conduit adapter
- Silicone caulk
- Threaded electrical PVC coupler
- Sections of 2-in. PVC pipe
- Unions reducers and valves